10 End of Summer Jobs for a Fantastic Fall

Summer may be coming to a close, but with the first day of autumn still a few weeks away, there is plenty of time to get your home and yard in tip-top shape before the cooler weather sets in. With the countdown on, I’ve rounded up the most important jobs for you to tackle to get ready for the fall. Let’s get busy!

Clean windows and inspect for gaps.

If you have window A/C units, tackle this job as you’re removing them. Windows are a prime culprit for heat loss, so have a look at all the windows in your home to see if you have any gaps. Small cracks and crevices can be sealed with caulk, but you’ll want to fill larger gaps with insulation or expandable foam. If you have single pane aluminum windows and you’re freezing every winter, it might be time for an upgrade.

Clean and store outdoor furniture.

If furniture is left outdoors during the winter, it will likely crack, split or rust depending on the material.  Before you turn it in for the winter, be sure to clean it well to avoid rot or damage and check for signs of mold and mildew. A thorough wash with hot soapy water or household cleaner will do the trick.

Reseal your deck.

The summer sun can be brutal on your deck, but so is the onset of snow, sleet, and freezing rain that we can expect over the next several months. Protect your wood by removing any leaves, sticks and those pesky helicopters, and follow it up with a good power wash. When the wood is dry, apply a protective sealant to condition the deck and help it stand up to winter.

Inspect your doors and apply weatherstripping.

Just like your windows, your doors are prime areas for air leaks. Inspect the areas around your doors and make sure they are airtight by repairing any old weatherstripping or broken door sweeps. Heating a home all winter costs a lot of money so don’t make it more expensive than it should be. An energy efficient home is a happy home.

Patch that leaky roof.

If the summer rain uncovered a leak in your ceiling or attic, don’t wait to have it looked at. The unpredictable winter can be a disaster for a roof that’s already damaged, so don’t hold out until it’s too late. Often times a small repair can stop the problem in its tracks.

Clean your gutters and check for clogs.

We’re in for a stellar leaf peeping season, but for homeowners that also means a lot of headaches in the clean-up department. Make sure your gutters and downspouts are prepared for the seasonal shed and flush everything through to ensure the water flow-through is up to par.

Get adequate insulation.

If you’re dreading another teeth-chattering winter, it’s time to add some insulation to your home. Over 75 percent of the houses that I visit in our area don’t have enough insulation and because of it, I get too many calls from frozen homeowners wondering what they can do. Insulation is inexpensive to install, can be done in less than a day and adds more to the resale value of your home than any other project. This one is a no-brainer.

Scrub out your garbage cans.

As the cold sets in, our furry friends get more desperate for food and will start visiting your trash looking for a free meal. Their sense of smell is uncanny so make sure your bins are cleaned out and future garbage is bagged properly. You don’t want rodents making their homes too close to yours.

Replace your air filters.

If your A/C has been cranking all summer, it’s a great time to clean and/or replace your air filtration systems. While you’re at it, have a look at all your vents including the dryer and remove any built-up debris. The harder those appliances have to work, the more they are going to cost you.

Inspect the hot water heater.

Don’t wait until it’s too late. Check your water heater for any decay or sediment build-up and be on the lookout for leaks or faulty pipes. If you have an inkling that the unit might be on the fritz, call in a pro for a routine inspection. It’s better to be safe than sorry come winter.

Bob O’Donnell is the owner of O’Donnell Bros. Inc., a Bristol-based home improvement company established in 1975. Email your questions to info@odonnellbros.com with the subject line “Ask the Pro.” All questions may be considered for publication. To contact Bob for your remodeling needs, call O’Donnell Bros. Inc. at (860) 589-5155 or visit http://www.odonnellbros.com. Advice is for guidance only.

Now is a Great Time to Repair or Replace That Driveway

A driveway is the entry point into almost every home, but a cracked surface can instantly date and devalue the property, especially if you’re a homeowner who is looking to sell in the near future. Depending on the condition of the driveway, patching, resurfacing or replacing the asphalt are all options to give your home a freshening up that will increase its resale value. Let’s take a look at the best ways to tackle this project.

If you’re wondering why your driveway has cracked or crumbled in the first place, the most likely culprits are sun and rain. The strong rays from the sun break down the surface of the asphalt while water from rain, ice, and snow run underneath, eroding the gravel which creates cracks and areas that begin to cave in. A driveway should last for at least 15 years depending on its environment, but as time passes and you start to see signs of wear, you’ll know that you’re ready for an upgrade.

If cracking is your problem, have a look at how thick the cracks are. If they are less than a quarter inch wide, you can use a liquid crack filler to fix them. First, use a screwdriver to remove any debris from the crack and then use a powerful stream of water from a hose or pressure washer ensure the inside of the crack is clean. Allow the area to dry completely. Once it’s dry, shake your crack filler vigorously to ensure all the ingredients are combined. Fill the crack flush to the rest of the pavement and then smooth it out if necessary. Allow the filler to dry, noting if the mixture sinks into the pavement and requires a second coat. Wait at least 24 hours before applying a second coat if necessary and then wait for an additional 24 to 48 hours before walking or driving on the repaired pavement.

If you have larger cracks, divots, or places in the driveway that have caved in slightly, you may need to resurface it. This is cheaper than replacing the entire driveway and can be a very effective alternative if the damage is not too severe. Concrete resurfacer can be purchased at any home improvement store and should be applied according to the instructions on the bag. Remember, resurfacing means that you won’t be able to use your driveway for a few days while it dries, so don’t take on this project the same weekend that you’re hosting a picnic or family party.

Finally, if you have large sinkholes or “birdbaths”, it’s likely that the foundation and drainage system underneath the asphalt or concrete is not working properly, so patching and resurfacing are only going to work temporarily. If this is the case, you’ll likely need to replace the driveway in its entirety in order to truly fix the problem. While this is the most arduous of the three options, it will also last the longest. A new driveway under good conditions should have a lifespan of 20 to 25 years and new pavement will give your home fantastic curb appeal. Again it’s important to note that installing a new driveway is a two-step process which includes laying the gravel for drainage and setting the pavement on top. Putting down the gravel sometimes means waiting two weeks for it to settle, so before you take on this kind of work, be aware of the time that it takes to complete.

Bob O’Donnell is the owner of O’Donnell Bros. Inc., a Bristol-based home improvement company established in 1975. Email your questions for Bob to info@odonnellbros.com with the subject line “Ask the Pro.” All questions may be considered for publication. To contact Bob for your remodeling needs, call O’Donnell Bros. Inc. at (860) 589-5155 or visit http://www.odonnellbros.com. Advice is for guidance only.

How to Deal with Water and Mold Before They Take Hold of Your Home

Mold is a problem that most homeowners have to deal with at one time or another. It’s the damaging by-product of water and moisture that can wreak havoc on your home, and more importantly, your health. So with summer on the way, now is a good time to inspect your house for mold and get rid of it before it does any kind of serious damage. But first, it’s a good idea to learn a little more about this pesky organism and why it demands to be treated so seriously.

You might be familiar with mold (otherwise known as mildew) from your shower or bathtub. Since the shower is often wet and the tiles are waterproof, water can sometimes seep into the grout, which, if it’s old and can’t handle its repelling duties properly, will become a breeding ground for mildew. So you’re left with microscopic organisms that feed off the moisture, allowing it to grow until you nail it with some Tilex and wait for the next clean. But what happens when mold starts to grow in the places you can’t reach to scrub – places like your ceiling, inside walls or attic? You’re probably saying, “Not in my house”. Well, guess again.

At least half the homes I visit for improvement and remodeling projects have a major mold problem and the owners don’t even know it. How? Because mold generally grows in places that you can’t see – like inside the walls and in the attic. What most people don’t realize is that mold reproduces, or grows, by releasing spores that you’re breathing in day after day.

How common is this? If you’ve ever had a leak, you’ve most likely had a mold problem. So what can you do about it? You can prevent mold by ensuring your home stays dry. Here are my top tips:

1. Keep your gutters and downspouts clean and clear so water can drain away from your house.
2. Don’t let a leaky roof go unfixed.  Get it patched up immediately and ask your contractor to inspect for any mold growth.
3. Make sure the ground around your house doesn’t slope inward towards the foundation where water can idle.
4. Inside the house, beware of any discoloration in the ceiling.
5. Ensure high moisture areas like bathrooms are well ventilated with good ceiling fans.
6. If a leak has poured into the carpet, don’t just leave it to dry. A damp area can attract mold in less than 48 hours.
7. Ensure large appliances such as refrigerators and washing machines aren’t leaking and have a catchment tray in the event of a malfunction.
8. If you use a humidifier, make sure it’s cleaned and the water is changed regularly.
9. If you feel that your house or basement has a high level of moisture, consider purchasing a dehumidifier to regulate the humidity and remove any excess moisture from the air.

If you’ve had a mold problem that you’ve tried to control by scraping, cleaning and repainting the area, don’t make the same mistake twice. If the mold keeps coming back, that means the issue runs deeper than the eye can see. It’s time to call in the pros.

Bob O’Donnell is the owner of O’Donnell Bros. Inc., a Bristol-based home improvement company established in 1975. Email your questions for Bob to info@odonnellbros.com with the subject line “Ask the Pro.” All questions may be considered for publication. To contact Bob for your remodeling needs, call O’Donnell Bros. Inc. at (860) 589-5155 or visit http://www.odonnellbros.com. Advice is for guidance only